#Jeep liberty bashbar how to
#Jeep liberty bashbar drivers

Still has a hole for that awful drain channel for the oil filter that is bolted onto the front diff.Inspired by styling from the Dakar and Jeepster concept vehicles, the Liberty was designed by Bob Boniface in 1998.

Congratulations! You now have skid plates!!!ДЇront suspension skid, covers front differential and some of the steering components. Once they are snug, torque them to 45 ft/lbs.ДЇinally, raise the transfer case skid into position, and bolt it into the four holes where you pressed the threads in. Make sure everything is all lined up, and begin tightening the bolt. Slide the front skid into position, and place the two front bolts loosely into position. Do not tighten the bolts yet as the front suspension skid plate must slide onto the same bolts below the transmission skid. You can start by raising it up into the front and loosely securing it with the bolts, and then do the same in the rear. This will assist you in holding it into position while you slide in the rear. There are two pieces that stick out of the front that will slide into two holes that are cut into the cross bar that is in the front. When bolting the skid plates on, it is extremely important that you follow this order!ДЇirst, put the transmission skid plate (longest of the three) into position. Once these are installed, it is a simple matter of bolting the skid plates into position.

#Jeep liberty bashbar drivers

(4 in the cross bar in the middle and two in the frame on the drivers side of the car by the transfer case).

There are a total of 6 of these threads to install.

Be sure to hold onto the nut/spacer in the middle so everything tightens down properly. Then, remove the black bolt and the threads will remain in the frame. When it is tight, torque it to 30 ft/lbs. As you tighten it, it will expand in the hole in the frame. Then, hold the nut with a wrench, and proceed to tighten the bolt. To do this, thread the black bolt into the silver threads until it is snug up against the nut. The black bolt and nut is what will press the silver piece into the frame. The silver metal is the piece that contains the threads.

#Jeep liberty bashbar how to

Sorry, I did not get a picture of the piece, but I will show you how to install it, as it took me a minute. There is just a hole cut into the frame and it needs to have a piece pressed into it in order to thread in the bolt. To mount it on the frame in the rear, you must first add the piece that contains the threads. The installation is pretty straightforward, although I did run into a few typical speed bumps: I will cover these in a moment.ДЇirst thing that you need to to to install them is to mount the Transmission skid plate. When they arrived they came with instructions and mounting hardware zip-tied onto the plates. I ordered them from the local Dodge dealership. First off let me start off with part numbers:ДЁ2210769: Front Suspension- My Cost $96.05 I can now with 100% certainty confirm that the Jeep Liberty skid plates do fit the Nitro, and I am providing the pictures to prove it. I DID IT!!!! I finally got my skid plates.